Dental LED curing light

Excellent performance
　　Using pure blue light LED as light source, with light guide tapered rod for high light concentrating. 　　Attractive designs, the machine is light and handy, which make doctors feel kind. Closely follow the world trends, it is exchanging product of the traditional dental halogen curing light.

　　Wirelessly design
　　 Using battery to supply power, without power thread, the doctor can exert his best medical skills heartily. While operating, have not high-voltage, using in safer and more reassurance condition.
　　 Light guide tapered rod can concentrate the light energy and raise part lightness.
　　
　　 No dazzling strong light
　　The LED light is composite resin sensitive blue light, not dazzling, therefore doctors can observe the curing position more clearly, and improve quality of operating. But the Halogen light only has little part which is blue light, and still has much useless non-blue light coming into the light spot even after filtered, which makes the light spot extremely dazzling, therefore you must use light-hiding slide, this will influence doctor observation in operation, And these useless non-blue light can transform into heat energy through resin, make some part turn into high temperature, which may burn dental marrow, and has the bad side effect such as toothache.

　　No noise and no vibration
　　LED hardly generate heat and does not need to dispel the heat with the annoying fan, there are no noise and vibration. To the doctors and patients, especially child patients, it is extremely comfortable.

　　Low maintenance expense
　　LED has a very long life-span (for more than ten thousand hours), but the life-span of general halogen lamp is only about 40-50 hours, with great cost and trouble of replacing a new lamp. The LED has very low power consumption, about 3 watts, but the general halogen lamp takes 75-100 watts.

　　Two-level light intensity design
　　Firstly penetrate with the weak illumination, and then use intensive light for fast solidification. This can suppress resin superficial shrinking too fast, prevent cracking between resin and tooth-hole edge.

　　Large capacity battery
　　Using 750 mAh rechargeable battery, each charge can use more than 60 times X 40 seconds.

　　Technical Parameter
　　• Battery: rechargeable Ni-H battery 4.8V 750 mAh
　　 • Spectrum range: 440nm-490nm
　　 • Operation time: weak light: 0s-9s(interval 1 second) intense light: 0s-60s (interval 10 seconds)
　　 • Turbo light guide: light inlet : φ 12.8mm ± 0.4mm light outlet: φ 7.6 mm ± 0.4mm
　　 • Depth of solidifying resin for 40s intense light: no less than 3mm
　　 • Automatically shut down time: 3 min ± 20s
　　Power souce: Ac 220 V (OR 110V) frequency: 50 / 60 Hz